Difference between revisions of "Tools reference"

From TED Notepad
Line 5: Line 5:
 
=====Did you know?=====
 
=====Did you know?=====
 
Back in the days of old printing presses, a ''string of characters'' referred to the way they gathered letters to print. All letters had a hole in the middle of the piece, allowing the characters to be gathered on a string (a real physical piece of cord or thread) using a needle. They would string them, tap them down on a solid surface and place them into the presses. This is how the term ''string of characters'' was born. It was actually a string. True story.
 
Back in the days of old printing presses, a ''string of characters'' referred to the way they gathered letters to print. All letters had a hole in the middle of the piece, allowing the characters to be gathered on a string (a real physical piece of cord or thread) using a needle. They would string them, tap them down on a solid surface and place them into the presses. This is how the term ''string of characters'' was born. It was actually a string. True story.
 +
 +
{{:Last Tool}}
  
 
=====Table of Contents:=====
 
=====Table of Contents:=====

Revision as of 00:31, 3 December 2016

This section is up to date for TED Notepad version 6.3.1.0.
Control page Control:menu:Tools
This section is up to date for TED Notepad version 6.3.1.0.
Control page Control:menu:Tools menu

This chapter describes all tools within the Tools menu.

Did you know?

Back in the days of old printing presses, a string of characters referred to the way they gathered letters to print. All letters had a hole in the middle of the piece, allowing the characters to be gathered on a string (a real physical piece of cord or thread) using a needle. They would string them, tap them down on a solid surface and place them into the presses. This is how the term string of characters was born. It was actually a string. True story.


Last Tool (Ctrl+L)

[Section link: Last Tool]

Repeats the last executed tool from the Tools menu. For example, if the last executed tool was Unique Lines, then Unique Lines is executed as Last Tool.

Note: Options chosen while running a tool the last time (if there are any) are remembered and automatically re-used.

Table of Contents: